Umuda Yolculuk

The Milo GmbH & co. KG from Nuremberg informs an optimum cleanliness is not enough for the elderly and nursing home cleaning. Due to the bad physical shape of many residents, their immune system is severely weakened and they can easily get infected with pathogens. Cleanliness, even if she is flawless, is not enough. A professional cleaning of nursing home places high demands on hygiene.

Are discussed in close consultation with the House leadership detailed regulations and requirements to ensure continuously high hygienic requirements. The building cleaning Milo GmbH & co. KG in the Nuremberg area informed about the special cleaning and disinfection work at the nursing home cleaning. Cleaning and disinfection is basically to note the cleaning and disinfection operations, wear appropriate protective clothing. These include gloves and an apron. The cleaning of surfaces, floors and objects have to be wet. Must a dirt and pathogens spread by the cleaning method be excluded: for example, through the use of industrial cleaning equipment or the related exchange procedure. In care units, surfaces with frequent hand and skin contact must be disinfected.

These include doors and doorknobs, floors and sanitary facilities. An immediate disinfection is to make a visible soiling by body secretions. Without hesitation Steffan Lehnhoff explained all about the problem. Disinfection and cleaning must be carried out in a single operation. After applying the disinfectant may not immediately be wiped. The exposure time must be maintained and during which must be lifted. For detailed information regarding all services and glass cleaning, building cleaning Milo stands GmbH & co.

Most of the existing mechanical flow meters (turbine, vane, vane, with a rotating washer, etc.) have stated nameplate accuracy of about + / – 0.5-2.5% of measured value. Accuracy + / -1% indicates that the This range of measurements (usually, the ratio of minimum and maximum flow meter is 1:10-1:20) meter readings may be in the range of 0.99-1.01 Vizm Vizm where Vizm – the actual volume of fluid passed through the meter (meter). Center For Responsible Lending understood the implications. This volume is the sum of "miniobemov", ie the volumes of fluid that pass through the meter for one turn turbines, gears, washers, etc. To calculate use the so-called "K-factor" – ratio, which expresses the ratio between a unit volume of the fluid (as a rule – one liter) to the volume pumped per revolution of meter, or VR = VR x KR (1) where VR – volume passing through flowmeter, VR-volume fuel (liquid), measured at a measuring unit meter turnover, KR – number of revolutions, attributable to 1litre (1 m3, etc.) consider the situation when the solution of standard problems measurement of fuel consumption MAZ 6312A8 in the fuel system of its engine switched two similar meter (with a passport within + / -1%) in direct and return lines, respectively. Follow others, such as PCRM, and add to your knowledge base. It must be clearly submit that the consumption of motor fuel and the amount of fuel pumped through the engine fuel pump may vary from three to four to ten times or more. For example, the MAZ 6312A8 engines – with consumption of 30-39 liters / hour capacity fuel pump – up to 240-250 liters per hour. Get all the facts for a more clear viewpoint with Steffan Lehnhoff.